Datalogger Setup - ELPRO ECOLOG TN2 Mode D'emploi

3. Settings in elproLOG ANALYZE

3.1 Datalogger Setup

Window „Datalogger Setup" is used to define the used measuring channels.
Refer to the elproLOG ANALYZE manual for detailed information about the following:
- Log Mode
- Log Start
- Log interval
- Module Tag
- Close, Reprogram, Print Status
- PIN
#
3.2 Extended Setup
Low point calibration...
High point calibration...
Direct calibration by downloading values...
Set date of calibration check
Define alarm parameters...
Reset alarm
Set date and time...
Display mode / Powersave...
Terminal mode parameters...
Set language...
Set printer...
Set temperature unit...
Set mean value measurement parameter...
Setup printout header texts
Programming of battery change time...
# Not all of these functions are available on all ECOLOG models!
Seite - 16
Getting Started
ECOLOG
Those 3 functions are used for logger adjustment
To enter the current data as calibration data into the logger status
See chapter 4.
With this function an alarm message may be resetted
To adjust the internal clock
See chapter 2.5.
Terminal mode (except TN2) can be used for communication
between an ECOLOG and various terminal programs such as
HyperTerminal. Further applications include integration of the logger
in a LabView environment and data transmission to a PLC
(Programmable Logic Control). Please request our documentation
(HC6001B) if you require further information.
Language selection for printouts.
Printer selection and size definition of the short log report
Display temperature unit selection. You have to choose between °C
and °F.
To suppress line frequency interferences.
Customer information that is printed on top of the printout.
To restart the logger after the battery has been replaced (see chapter
2).
D-EZ-6003Bh
11. 2016