Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
Positioning cuff
• Bare your left wrist, making sure that the circulation in the
arm is not restricted by any clothes etc. that are too tight.
Position the cuff on the inside of your wrist.
• Fasten the cuff with the Velcro fastening so that the upper
edge of the monitor is positioned approx. 1 cm below the
ball of your thumb.
• The cuff has to be fitted tightly around the wristbut should
not constrict it.
1
2
Important: The instrument should only be operated with the
original cuff.
Correct posture
• Rest for approx. 5 minutes before each measurement.
Otherwise there may be divergences.
• You can perform the measurement
either sitting or lying down. It is es-
sential to support your arm and have it
at an angle. Always make sure that the
cuff is level with your heart. Otherwise
All manuals and user guides at all-guides.com
• In order not to distort the result, it is important to keep still
Measuring blood pressure
• Start the blood pressure monitor with the start/stop but-
• Before the measurement, the last saved test result is briefly
3
• The cuff is pumped up to 190 mmHg. Cuff air pressure is
• After the pressure has been completely reduced, the
• Measuring can be cancelled at any time by pressing the
• "Er_" appears if it has not been possible to perform the
• • • • • • • • • • • • •
• The test result is saved automatically.
13
there may be serious divergences. Relax your arm and the
palms of your hands.
during the measurement and not talk.
ton
. A beep and a brief display of all the symbols con-
firm that the device is switched on.
displayed. If there is no measurement in the memory, the
instrument always displays the value "0".
released slowly.
If a tendency towards high blood pressure is already de-
tectable, the cuff is pumped up again and cuff pressure
tectable, the cuff is pumped up again and cuff pressure
increased further. The pulse symbol flashes
as a pulse is found.
systolic pressure, diastolic pressure and pulse readings
are displayed.
start/stop button
.
measurement properly. Observe the section in these in-
structions on error messages/troubleshooting and repeat
the measurement.
as soon
Publicité
Table des Matières
