Wahoo SPEEDPLAY Easy Guide De Démarrage Rapide page 5

CLEAT INSTALLATION
6. ADJUST THE LIMIT SCREWS TO SET THE DESIRED FLOAT
Tighten the Limit Screws to reduce the amount of
float ("heel movement") experienced by the foot
while pedaling.
Housings are labelled "Heel In" & "Heel Out"
to guide which Limit Screws to adjust.
Preferred float range is unique to each rider. If you are
unsure of your float preference, begin with medium float
and adjust as needed.
Note: Do not unscrew the Limit Screws from the Housing when adjusting float, and
do not further tighten the Limit Screws once they have made contact with the tip of
the Spring.
7. FIT THE CLEAT COVER OVER THE EDGES OF THE PROTECTOR PLATE
Cleat Covers are labeled "LEFT" or "RIGHT".
Grip the shoe and apply force with the palm of the hand to each of the four
corners to ensure that the Cleat Cover has properly covered the edges of the
Protector Plate.
The Cleat Cover should fit flush to the Cleat Surround when installed correctly.
Note: Failure to properly complete this step may result in the Cleat Cover falling o .
8. APPLY PTFE DRY LUBE TO THE SPRING OPTIONAL
Reduce the engagement force required to clip
into the pedals by applying a small amount of
"PTFE Dry Lube" to the Spring.
Wipe away any excess lube.
continued
Right Shoe
Right Shoe - Installed
Right Shoe
Right Shoe