Table des Matières
Publicité
CLEAT INSTALLATION
1. CHOOSE THE SHIMS FOR THE BASE PLATE THAT BEST FIT THE SOLE OF THE SHOE
Shims
Base Plate
5-F and 5-R Shims ship pre-installed to the Base Plates,
but can be substituted with the Blue 6-F and 6-R Shims.
Extra Shims may be required between 5-F/6-F Shims
and the sole of the shoe.
CAUTION
The Base Plate/Shim Combo may not create a "perfect" fit to the bottom of the
shoe, but for best results it is important to use the Shims that provide the "best" fit.
2. SCREW THE BASE PLATE TO THE SHOE USING THE BASE PLATE SCREWS
Base Plate Screws ship in two lengths:
(Short/Black & Long/Silver)
Use the shortest screws that allow at least five
full turns of engagement with the socket in the
sole of the shoe.
Set the desired fore-a position then tighten
the Base Plate Screws.
Recommended tightening torque: 4 Nm.
3. FIT THE CLEAT SURROUND AROUND THE BASE PLATE
Cleat Surrounds are labeled "L" or "R".
Note: COMP pedals do not ship with
Cleat Surrounds.
Shims
Base Plate
Right Shoe
Right Shoe
Publicité
Table des Matières
