Installation Instructions - exodraft RSVG Serie Instructions

• UK
4
1.2

Installation instructions

The fan is designed to be fitted directly on top of brick or steel chimneys, as long as these are stable and level.
Before fitting onto a chimney
If
the fan is to be mounted onto a brick chimney
the fan is to be mounted onto a steel chimney.
the fan is a RSVG 315...
Before fitting onto the brickwork of a chimney
Step
1 Measure the inside diameter of the chimney and adjust
the size of the hole in the mineral wool mat accordingly
Note that there must always be a minimum of 20 mm
of mat surface at any point around the circumference of
the hole
2 Fit the location brackets in the grooves on the
underside of the bottom section and fasten using the
nuts and bolts supplied
Note that the bolts are to be inserted from beneath
the brackets.
the chimney must have location brackets – see below
A flange is required (supplied as extra) – see below
the impeller is secured with a safety bracket for
transportation
Remove the transportation safety bracket located near the
impeller and check that the impeller can turn freely
Action
3000127 RSVG DK DE NO SE UK NL FR 20200511
then