Machine Assembly; Preparing To Work - Invertek SHT 500 Manuel D'utilisation

6
EN

4. MACHINE ASSEMBLY

WARNING!
Mount the components
very carefully so as not to impair the safety
and efficiency of the machine. If in doubt, con-
tact your dealer.
WARNING!
Make sure the machine is
not plugged into the mains socket.
WARNING!
Unpacking and complet-
ing the assembly should be done on a flat and
stable surface, with enough space for moving
the machine and its packaging, always making
use of suitable equipment.

5. PREPARING TO WORK

1. CHECKING THE MACHINE
WARNING!
Make sure the machine is
not plugged into the mains socket.
Before starting work please:
– check that the mains frequency and voltage is
the same as the rating data on the "Identification
Plate" (see chap. 1 - 8.8).
– check that the trigger switches and the safety
switch should move freely without forcing and re-
turn automatically and rapidly back to their neu-
tral position;
– check that the cooling air vents are not ob-
structed;
– check that the power cable and extension lead
are not damaged;
– check that handgrips and protection devices are
clean and dry, correctly mounted and well fas-
tened to the machine;
– check that the cutting devices and guards are not
damaged;
– check that the machine is not showing signs of
wear or damage due to knocks or other causes,
and carry out the necessary repairs.
All manuals and user guides at all-guides.com
Disposal of the packaging should be done in ac-
cordance with the local regulations in force.
1. MOUNTING THE FRONT GUARD
– Position the front guard (1) on the end section
– Secure the guard using the two screws (3).
2. ELECTRICAL CONNECTIONS
are not compatible.
– Always handle and connect electric cables
– Keep electric sockets or cables away from
– Power the machine using a residual current
The quality of the extension leads must be no less
than H07RN-F or H07VV-F, with a minimum sec-
tion of 1.5 mm and a recommended maximum
length of 30 m.
To avoid overheating, do not keep the extension
lead rolled up during use.
tion of any electrical equipment to the mains of
a building must be installed by a qualified
electrician in conformity with the regulations in
force. Incorrect wiring can cause serious in-
jury and even death.
MACHINE ASSEMBLY / PREPARING TO WORK
(If supplied separately) - (Fig.1)
of the power unit (2).
DANGER!
Electricity and moisture
in dry conditions.
wet and damp areas (e.g. puddles or wet
ground).
device (RCD Residual Current Device) with
max. 30 mA tripping current.
DANGER!
The permanent connec-