Zanussi ZBA15021SA Notice D'utilisation page 12

ponents of the refrigerant circuit become
damaged.
If the refrigerant circuit should become dam-
aged:
– avoid open flames and sources of ignition
– thoroughly ventilate the room in which the
appliance is situated
• It is dangerous to alter the specifications or
modify this product in any way. Any damage
to the cord may cause a short-circuit, fire
and/or electric shock.
Warning! Any electrical component
(power cord, plug, compressor) must be
replaced by a certified service agent or quali-
fied service personnel to avoid hazard.
1. Power cord must not be lengthened.
2. Make sure that the power plug is not
squashed or damaged by the back of
the appliance. A squashed or damaged
power plug may overheat and cause a
fire.
3. Make sure that you can come to the
mains plug of the appliance.
4. Do not pull the mains cable.
5. If the power plug socket is loose, do not
insert the power plug. There is a risk of
electric shock or fire.
6. You must not operate the appliance
without the lamp cover (if foreseen) of
interior lighting.
• This appliance is heavy. Care should be tak-
en when moving it.
• Do not remove nor touch items from the
freezer compartment if your hands are
damp/wet, as this could cause skin abra-
sions or frost/freezer burns.
• Avoid prolonged exposure of the appliance
to direct sunlight.
• Bulb lamps (if foreseen) used in this appli-
ance are special purpose lamps selected for
household appliances use only. They are not
suitable for household room illumination.
Daily use
• Do not put hot pot on the plastic parts in the
appliance.
12
All manuals and user guides at all-guides.com
• Do not store flammable gas and liquid in the
• Appliance's manufacturers storage recom-
Care and cleaning
• Before maintenance, switch off the appli-
• Do not clean the appliance with metal ob-
• Regularly examine the drain in the refrigera-
Installation
Important! For electrical connection carefully
follow the instructions given in specific
paragraphs.
• Unpack the appliance and check if there are
• It is advisable to wait at least four hours be-
• Adequate air circulation should be around
• Wherever possible the back of the product
• The appliance must not be located close to
• Make sure that the mains plug is accessible
• Connect to potable water supply only (If a
Service
• Any electrical work required to do the servic-
appliance, because they may explode.
mendations should be strictly adhered to.
Refer to relevant instructions.
ance and disconnect the mains plug from
the mains socket.
jects.
tor for defrosted water. If necessary, clean
the drain. If the drain is blocked, water will
collect in the bottom of the appliance.
damages on it. Do not connect the appli-
ance if it is damaged. Report possible dam-
ages immediately to the place you bought it.
In that case retain packing.
fore connecting the appliance to allow the oil
to flow back in the compressor.
the appliance, lacking this leads to overheat-
ing. To achieve sufficient ventilation follow
the instructions relevant to installation.
should be against a wall to avoid touching or
catching warm parts (compressor, condens-
er) to prevent possible burn.
radiators or cookers.
after the installation of the appliance.
water connection is foreseen).
ing of the appliance should be carried out by
a qualified electrician or competent person.
www.zanussi.com