Troubleshooting - Dynex DX-E101 Guide De L'utilisateur

All manuals and user guides at all-guides.com
Dynex5x7-multi.book Page 10 Friday, September 9, 2005 12:32 PM
10
4 Click Internet Protocol (TCP/IP) in the This connection uses the
following items list, then click Properties. The Internet Protocol (TCP/IP)
Properties dialog box opens.
5 Click Use the following IP address, then type values for:
• IP address–The IP addresses on your network must be within the same
range. For example, if one computer has an IP address of 192.168.0.2,
the other computers should have IP addresses that are sequential, like
192.168.0.3 and 192.168.0.4
• Subnet mask–The subnet mask must be the same for all the
computers on the network. The subnet mask is usually 255.255.255.0.
• Default gateway–The default gateway is the LAN IP address of your
wireless router. For information, see your router's user guide.
6 Click Use the following DNS server addresses, then type your router' s
LAN IP address. For information, see your router' s user guide.
7 Click OK.

Troubleshooting

If you are having problems with your network, check the following:
V
ERIFY EACH COMPUTER
• Make sure that each computer on your network has a unique computer
name. If more than one computer has the same computer name, the
network will not work.
• Make sure that all the computers in your network have the same workgroup
name.
'
S IDENTIFICATION
Troubleshooting