Asko T784C Instructions D'installation page 13

Condensed water
The machine is supplied as shown in Option 1
(inset). This means that the condensed water
is pumped into the condensed water container.
This must then be removed and emptied by
hand.
Option 2 allows you to remove the small short
hose from the nipple. Attach the rubber hose
supplied to the same nipple. The water can
then be pumped out into a sink or a fl oor drain
(2a).
Start instructions
Start instructions
You will be prompted to select the display
language when you have connected your
machine and start it for the fi rst time.
1. Turn the programme selector and choose the
required language.
2. Press Start to save the selection and return to
the programme menu.
Start instructions
The fi rst time the machine is connected to a
power supply, you need to select the language
for the machine's menus and set the clock. If
the power is cut before this is completed, the
process must be restarted.
Note:
All selections must be made.
Note!
• Do not pull on the drain hose and do not
stretch it or allow it to become kinked as it
could get damaged.
• Secure the hose carefully (e.g. by trying it to
a tap to make sure it cannot slip during use).
Otherwise there is a risk of overfl owing
water which could cause damage.
Warning!
If the tumble dryer is to be connected to a
drainage system already in use by another
appliance it is essential to fi t a non-return
valve.
The non-return valve will prevent the risk of
back-fl ow into the dryer which could cause
damage.
Select language
If you want to use the default language, press
the Start button to confi rm. Otherwise, use
the up and down arrow buttons to select:
AU English, US English, svenska, dansk, norsk,
suomea, Francais, Deutsch, Italiano, espanol,
Русский, nederlands.
Press the Start button to confi rm.
Set the clock to 12h, 24h, or remaining
program time display
The clock is displayed in the middle of the
display.
Use the up and down arrow buttons to choose
12h, 24h, or remaining program time display.
Press the Start button to confi rm.
If you select 12h or 24h, the clock setting menu
automatically opens.
Set the clock
Press the up arrow button until the correct
hour is displayed. Press the program selector
(the big arrow) to save. Press the down arrow
button until the correct minutes are displayed.
Press the Start button to confi rm.
English
13