Step 1-B: Insert & Route Cable - weBoost DRIVE REACH FLEET Guide D'installation

______
Step 1-B: Insert & Route Cable
After hole has been drilled, insert NMO Mounting Cable
through (connector end fi rst) and remove collar.
Position threads of the cable mount above vehicle surface.
Apply included silicone grease to the o-ring on the collar
then screw the collar to the base mount. Ensure the mount is
centered in the hole and tighten with wrench.
remove
collar
insert through hole
For a professional installation, we recommend routing the cable
under the headliner and down through the side trim panel to
the desired booster location on the fl oor of the vehicle.
4
PROFESSIONAL VEHICLE SIGNAL BOOSTER KIT DRIVE REACH FLEET
apply silicone grease
screw collar
to base mount
side trim panel