CABASSE Xo SYSTEM 92 dB Notice D'utilisation page 14

All manuals and user guides at all-guides.com
Positionning of Xo SYSTEM
Xo SYSTEM satellites have all the same
technical features, they can be used on any channel. All
the satellites are magnetically shielded to prevent
interference with the image of your television set, they
can thus be placed near any screen.
Front left and right satellites must be directed towards
the listening area and placed on either side of the screen
with at least a distance of 2 and 5 m (7 ft and 16 ft)
between the 2 satellites.
The centre satellite should be placed as close as possible to the screen: on the top, below,
or directly on your television set. Place the satellite at the vertical of the screen for a perfect
cohesion and precision between dialogues and picture.
Rear satellites should be placed against the side walls, at listening height or higher if
possible and slightly behind the listening area.
The subwoofer should be placed in the front listening area. To get the best result, it is always
necessary to carry out tests according to the acoustics of the room. To prevent interference
with the screen of your television set, place the subwoofer at least 0,6 m/2 ft of your
television set.
Connections
Before making any connections turn off your receiver and unplug it from the outlet. Not
doing so may result in damage to your system.
Never use broken or frayed wiring, which can result in electrical shock or damage to
your system.
The use of the ∑ Cabasse module is essential to the correct operation of Xo SYSTEM,
therefore it is necessary to respect the following connection instructions.
Use 3 crystal cables of 6 m/20 ft to connect the "centre", " front left " and " front right " output
of the audio video amplifier to the centre, front left and right left satellites.
Use 2 crystal cables of 15 m/49 ft to connect the "rear left" and "rear right" outputs of the
audio video amplifier to the "rear left" and "rear right" satellites.
It is imperative before any connection to respect the setting
in phase by connecting the terminals +/red of the amplifier to
the terminal +/red of the satellites. Proceed then in the same
way for terminals -/black.
Connection of the satellites is carried out with a push button
which once slackened locks your connection.
14