Electrical Connection - Dunavox DXFH-16.46 Manuel De L'utilisateur

b. Installation of Your Wine Cooler
 This Wine Cooler is designed to be free standing installation.
 Place your Wine Cooler on a surface that is strong enough to support it when it is fully loaded.
 Allow 10 cm of space between the back and sides of the Wine Cooler, which allows the
proper air circulation to cool the heat sink.
 Locate the Wine Cooler away from direct sunlight and sources of heat (stove, heater, radiator,
etc.). Direct sunlight may affect the acrylic coating and heat sources may increase electrical
consumption. Extreme cold ambient temperatures may also cause the unit not to perform
properly.
 Avoid locating the unit in moist areas.
 Plug the Wine Cooler into an exclusive, properly installed-grounded wall outlet. Do not under
any circumstances cut or remove the third (ground) prong from the power cord. Any questions
concerning power and/or grounding should be directed toward a certified electrician or an
authorized service center.
 After plugging the Wine Cooler into a wall outlet, allow the unit to cool down for 2-3 hours
before placing any items in the compartment.
 Rest the wine cooler for 24 hours after transportation.
c.

Electrical Connection

Warning
 This appliance should be properly grounded for your safety. The power cord of this appliance
is equipped with a three-prong plug which mates with standard three prong wall outlets to
minimize the possibility of electrical shock.
 Do not under any circumstances cut or remove the third ground prong from the power cord
supplied. For personal safety, this appliance must be properly grounded.
 This appliance requires a standard 220-240 Volt AC / 50Hz electrical ground outlet with three-
prong. Have the wall outlet and circuit checked by a qualified electrician to make sure the
outlet is properly grounded. When a standard 2-prong wall outlet is encountered, it is your
responsibility and obligation to have it replaced with a properly grounded 3-prong wall outlet.
 The cord should be secured behind the appliance and not left exposed or dangling to prevent
accidental injury.
 The appliance should always be plugged into its own individual electrical outlet which has a
voltage rating that matches the rating label on the appliance. This provides the best
performance and also prevent overloading house wiring circuits that could cause a fire hazard
from overheated. Never unplug the appliance by pulling the power cord. Always grip the plug
firmly and pull straight out from the receptacle. Repair or replace immediately all power cords
that have become frayed or otherwise damaged. Do not use a cord that shows cracks or
abrasion damage along its length or at either end. When moving the appliance, be careful not
to damage the power cord.
INSTRUCTION MANUAL
Improper use of the grounded plug can result in
the risk of electrical shock. If the power cord is
damaged, have it replaced by an authorized
service center.
22