Foppapedretti ISOPLUS Instructions De Montage page 26

All manuals and user guides at all-guides.com
INSTALLING THE CAR SEAT IN THE VEHICLE
Group 1 installation (children from 9 to 18 kg) - See figure "1a, 1b, 1c"
a. Pull lever "A" (16) outwards and, keeping it pulled, fully extend the ISOFIX connector
"B" (5), until it stops. Release the lever and make sure that the ISOFIX connector is
locked in the extended position. Repeat this process on both connectors of the car
seat. Open up the container compartment door (13) on the rear side and pull out
the Top Tether belt (4) completely, unhooking the carabiner. Close the container
compartment door again.
b. Align the ISOFIX connectors with the anchoring points fixed to the vehicle passenger
seat and press until you hear a "click". The indicator (14) on both brackets will turn
green, confirming that they have attached. Check that both brackets are attached
correctly. Push the car seat towards the passenger seat, making sure that both
ISOFIX connectors are extended in the same position.
c. Attach the Top Tether to the appropriate anchoring point indicated by the symbol:
Tighten the Top Tether belt until the indicator turns green. The Top Tether belt
must pass over the backrest of the vehicle passenger seat, it must never pass over
the headrest. If necessary, lift up or remove the headrest from the passenger seat.
Note: before use, check that the ISOFIX connectors are correctly attached on both
sides, when pulling the car seat, they must not detach.
REMOVING THE CAR SEAT FROM THE VEHICLE
Loosen the Top Tether belt to reduce the fixing tension. Unhook the belt anchoring
carabiner.
Slide button (15) to release the connectors from the vehicle's ISOFIX anchoring device.
Remove the car seat from the vehicle.
INSTALLING THE CAR SEAT IN THE CAR
Group 2-3 installation (children from 15 to 36 kg)
•
Group 2-3 (SEMI-UNIVERSAL). Follow the installation for the group 1 ISOFIX
anchoring system, WITHOUT using the Top Tether belt.
•
Group 2-3 (UNIVERSAL). It is possible to install the car seat with the vehicle's
3-point seat belt only, WITHOUT using the ISOFIX connectors and WITHOUT the
Top Tether belt. Follow just the installation steps with the vehicle's 3-point seat belt,
see "Group 2 and 3 use (from 15 to 36 kg)".
• ENGLISH •
INSTALLING THE CAR SEAT
26