Unloading Fasteners; Clearing Jams - Pro-Point 8561193 Manuel D'utilisateur

8561193
23 Gauge Pin Nailer
V1.0
UNLOADING FASTENERS
Unloading is the reverse of loading. Always disconnect
the air source before unloading.
WARNING: Always unload all fasteners before removing
tool from service.
WARNING: Always disconnect the air source
before unloading.
CLEARING JAMS
Occasionally, a fastener may become jammed in the firing
mechanism of the tool, making the tool inoperable. To
remove a jammed fastener, follow the steps below:
1.
Disconnect the tool
from air source.
2. Remove fasteners
from the tool. Failure
to do so will cause
the fasteners to eject
from the front of
3.
the tool.
Remove the non-
marring pad(G) from
the nose.
@):J
@):J~ ~
\ N"•(F)
Nose screws(D)
~
Nose plate(E)
" \Non-marring pad(G)
4. Completely remove the small nose screws (D) and
the top nose plate (E) to reveal the
jammed fastener.
5. Using caution not to bend or damage the driver
blade, use pliers or a screwdriver if required to clear
the jammed fastener.
6. Put the nose plate (E) back on the nose
(F),
fastening it with the screws (D).
7. Reconnect the tool to the air source.
18 For technical questions call 1-800-665-8685