Air Supply And Connections - Pro-Point 8561193 Manuel D'utilisateur

8561193
23 Gauge Pin Nailer
V1.0
6. Always handle the tool with care:
a. Respect the tool as a working implement.
b. Never engage in horseplay.
c. Never pull the trigger unless nose is directed
toward the work.
d. Keep others a safe distance from the tool
while tool is in operation as accidental
actuation may occur, possibly causing injury.
AIR SUPPLY AND CONNECTIONS
1. The connector on the tool must not hold pressure
when air supply is disconnected. If an incorrect
fitting is used, the tool can remain charged with air
after disconnecting and thus will be able to drive a
fastener even after the air line is disconnected,
possibly causing injury.
2. Do not use any type of reactive gases, including,
but not limited to, oxygen and combustible gases,
as a power source. Use filtered, lubricated,
regulated compressed air only. Use of a reactive
gas instead of compressed air may cause the tool
to explode which will cause death or serious
personal injury.
3. Use only a pressure-regulated compressed air
source to limit the air pressure supplied to the tool.
The regulated pressure must not exceed 100 psi. If
the regulator fails, the pressure delivered to the tool
must not exceed 200 psi. The tool could explode
which will cause death or serious personal injury.
14 For technical questions call 1-800-665-8685