LaserLiner WoodTester Mode D'emploi page 12

Wet/dry LED indicator for group B
7b
Group A
9 1 3 1 6 1 9 21
1 1 1 5 1 9 23 25
Group B
If a measurement for a group B wood is now made, the material's moisture in %
will be displayed in the lower scale. In this case, the right-most illuminated LED
(regardless of colour) and the colour-scale beneath it are used to determine if the
wood is to be classified as „dry", „moist" or „wet". Evaluation is now based on
the lower colour scale. Green = dry, yellow = moist, red = wet.
Example shown: 23 %, red section of the lower scale = wet.
If a measurement should produce no change of the LEDs, it is possible
!
that the measured material is too dry. Perform a self-test of the device
with the protective cap to make sure the device is in good working
order.
Auto-Hold function
8
The last measurement value will continue to display for about 5 seconds after
removing the device from the measured material. During this period the LEDs
will blink and show the last measurement value. As soon as only the first green
LED blinks, the device is ready to make a new measurement.
Functional and operational safety is only warranted when the instru-
ment is operated within the specified climatic conditions and is only
!
used for those purposes for which it is designed. The assessment of
measurement results and actions taken as a consequence lie in the
user's scope of responsibility, depending on the given type of work.
12
EN
23%
27%
dry moist
wet