Lubrication - Unitec PROFI AZ-117 Mode D'emploi

Instructions for use
t
– Lock the vehicle's wheels to achieve the appropriate stability for the
lifting process.
– See vehicle manufacturer's manual to locate the permitted lifting points
for the vehicle. Place the floor jack so that the plate is at the centre of the
lifting point.
– Always apply the handbrake so that the wheels are locked.
– Step on the foot pedal to lift the plate until the vehicle moves. Check
whether the plate is central and right at the lifting point. the foot pedal
is not suitable for lifting the load, but only there to lift the plate quickly.
If necessary use suitable adapters to prevent damage to the points of
contact on the vehicle.
– Continue to lift the vehicle to the required height with the aid of the floor
jack handle. Support the load after lifting with appropriately placed chas-
sis stands before starting work on the vehicle.
– the manual force required here exceeds 400n, please ask a second
person to assist you.
– Carefully open the release valve by slowly turning the handle anti-clock-
wise.
– Use only SAe 10 hydraulic oil.
– Place the floor jack on an even surface and lower the platform. then
remove the oil tank sealing plug.
– Fill the oil tank until the oil level is directly below the bottom edge of the
filler opening. Put the oil tank sealing plug back in.
– Carry out the ventilation process described below.
– Fully open the release valve by turning the handle anti-clockwise as far
as it will go.
– turn the floor jack over so that the oil can run out of the filler opening.
– refill with new oil through the filler opening. Avoid dirt or other foreign
material from getting in when filling. Fill the oil tank until the oil level
is directly below the bottom edge of the filler opening. Put the oil tank
sealing plug back in.
– Carry out the ventilation process described below.
– Apply lubricating oil to all moving parts if necessary.
– In case of only light use, a lubricating process every six months is
adequate.
– In case of heavy and consistent use, a lubrication process is
recommended every month.
10026 Bed._A5_130725.indd 11
FUNCTIONS
AND
OPERATION
Operation
Putting the floor jack
up
Lowering the floor jack
MAINTENANCE
To top up the oil:
To change the oil:

Lubrication:

25.07.13 14:13
11