Unitec PROFI AZ-117 Mode D'emploi page 10

Description
Spezification
ASSEMBLY
Assembling
the handle
10
10026 Bed._A5_130725.indd 10
Instructions for use
t
28. KEEP YOUR HANDS AND FEET AWAY FROM THE FLOOR JACK'S HINGE
MECHANISM AND FROM THE FLOOR CONTACT AREA WHEN LOWE-
RING THE LOAD!
29. tHIS FLOOr JACK IS OnLY DeSIGneD FOr LIFtInG One PArt OF tHe
VeHICLe. DO nOt MOVe Or rePOSItIOn tHe VeHICLe WHILSt It IS
LIFteD WItH tHe FLOOr JACK.
30. Jacks must be maintained and repaired according to the manufacturer's
instructions. Such maintenance and repair work must be carried out by
experts.
Always give the lifted vehicle additional support using chassis stands.
Never use the floor jack alone to support the load. Holding the load over
long periods can overload the appliance and lead to personal injury and
material damage.
the 10026 model has a maximum capacity of 6,000 lbs / 3,000 kg. the lifting
range of this floor jack is 145 - 500 mm. the floor jack features an overload
valve, which helps to prevent the appliance from failing. the bypass system
enables safe operation.
Maximum load bearing capacity:
Lifting range:
– Before assembly,
please remove the
piece of rubber fitted in
the lifting unit; (this was
put there as a transport
safety measure and
is not part of the floor
jack).
– take note of Figure 1
for how to carry out
this step. remove the
screw found on handle
piece 1. Fasten the
handle pieces 1 and
2 in order to align the
holes on both pieces with each other. Put the screw back in and tighten
it.
– Fully undo the screw located in the handle. A socket appears for fitting
the assembled handle (Figure 2).
– Align the rectangular opening on the underside of the handle with the
rectangular bolt inside the handle socket.
– Secure the handle at its installation position by tightening the screw on
the handle socket.
– Close the release valve by turning the handle clockwise as far as it will
go.
3 tonnes
145 - 500 mm
FIGURE 1
Screw
Handle Handle
piece 1 piece 2
FIGURE 2
Underside
of handle
Screw
25.07.13 14:13