Injecta NIKE TL Manuel D'installation page 5

4 DISPLAY
a) As soon as the pump is powered, the display shows
runs a check
:
If the parameters cannot be read properly from EEPROM, the display shows
The default parameters can be reset using the UP key (pressed for 4 seconds).
The default parameters are:
After the default parameters have been reset, these parameters can be modified from the programming menu (see chap.
3)
a) During the filter time, the display shows a mobile "
b) During the delay time, the display shows:
c) During the dosing time, the display shows
During lock-out, the display shows a counter which decreases to 0.
d)
e) During priming the display shows:
f) During standby the display shows:
g) During manual trigger, the display shows the blinking filter, dosing and lock-out messages.
h) When idle (not included in the described cases) the display shows:
NIKE TL
8888
Password = 000
T filter = 005
T delay = 005
Dosing time = 055
Lock-out time = 000
Trigger signal = HI
-
" on the three red displays.
deL
: run
Pr
SbY
Cod. 0000136903 rev. 1.4
for approximately 0.3 seconds, during which the pump
FAIL
and the pump remains on standby.
on
Page 4/4