Getting Started; Scope Of Application - L-TEC IONSTAR Notice D'utilisation

Getting started

6.
Connect the IONSTAR to the compressed air supply.
The device is grounded is via the compressed air hose
 An electrically conductive compressed air hose must be used with the
IONSTAR
 Ensure that the incoming air pressure to the pistol is within minimum 3 to
maximum 5 bar
The ionization device is ready for operation

Scope of application

7.
Point the ionizer at the part to be cleaned and press the operating lever.
• Distance 10 - 40 cm
• During operation, the green LED lights up
- LED off = no ionisation
- LED blinks off and on = only partial ionisation. Check that incoming
pressure is within required range of minimum 3 to maximum 5 bar
- LED on = ionisation in progress; normal operation
• When used as intended, the IONSTAR device also complies with the technical
regulation TRGS 727, version 8/2016, "avoidance of ignition hazards due to static
charges"
Helpful paint-spraying tips
 Use your IONSTAR in the same way, with the same pressure and at the
same distance as you would use your spray gun.
 Use a dust cloth; apply this BEFORE ionizing with your IONSTAR, NOT at the
same time.
 Ionize thoroughly. Do not forget parts like door frames, flanges and beads
etc.
 Coat immediately after ionizing.
 For best results, ionize between the application of each layer.
 Do not touch the vehicle after ionizing with your IONSTAR. If you do
however, it is ESSENTIAL to re-ionize thoroughly.
 Allow yourself time to complete the described process, this way you can
ensure achieving optimum results.
All manuals and user guides at all-guides.com
Seite 18 von 30