Quick Start - Hama Nano Mode D'emploi

Serial number
A serial number is included with each product. This
serial number is required to install the software and it
entitles you to access additional services. You should
therefore keep this number in a place where you can
find it later on.
Where to find the serial number
The serial number is located on the back side of your
CD case.
When will you need the serial number?
You will need the serial number when you start the
MAGIX TV & Video Recorder for the first time or when
you want to register the software with MAGIX.
Note: We highly recommend the free product regis-
tration, because you will then be entitled to download
program updates, access the MAGIX support web
pages, and activate codecs.
Hama Nano DVB-T Dongle anschließen:
1. Connect the Nano DVB-T dongle directly to a USB 2.0
compatible port on your PC.
2. If necessary, connect the antenna converter so that
you can connect an indoor antenna (for example).
3. Connect the included passive DVB-T rod antenna to
the dongle.
Keep this in mind during the first installation:
The driver installation is not complete until you have first
connected the Nano DVB-T dongle. Wait for the relevant
system message from your operating system before you
start the MAGIX software.
16
Exchangeable silicon cases:
The receiver comes with three exchangeable silicon
cases in different colours, which you can put on the
DVB-T dongle according to your taste.
To change the silicon cases, proceed as follows:
1. Ground yourself by touching a suitable object
(e.g. heating radiator) to prevent undesired static
discharge.
2. Unplug the Nano DVB-T dongle after you have
switched off the PC.
3. If the receiver was connected to the computer for a
long period of time, wait a few minutes so that the
receiver can cool down.
4. Carefully remove the black silicon case from the Nano
DVB-T dongle and replace it with one of the other
included cases.
When you do this, be very careful and do not use brute
force, since otherwise the receiver could easily be
damaged.

Quick Start

You should read this chapter if you want to start recor-
ding right away, without having to read through long
explanations. It will provide you with a brief explanation
of everything you need, while you simultaneously record
your first programmes and store them on CD or DVD.
Tip: Don't forget to use the Task Wizard. It shows you
how to use all of the important functions. After you start
the program, you can access it directly via the "Tasks"
menu.