Koenic KHT 200 Mode D'emploi page 19

Cutting hair
Set the desired cutting length as described
8
in chapter "Comb attachment and cutting
length". Switch on the hair clipper with
the on/off switch. Place the clipper head on
the hair and move against the direction of
the hair growth. Cut with slow and careful
movements.
Note
Depending on the position of the product
and the resulting angle, the cutting lengths
may differ.
Fine tuning/cut
Use the hair clipper without comb
9
attachment for a precise trimming of the
neckline or trimming of contours.
Cleaning and care
When cleaning, never use solvents or abrasive
materials, hard brushes, metallic or sharp
objects. Solvents are harmful to human health
and can attack plastic parts, while abrasive
cleaning mechanisms and tools may scratch the
surface(s).
• After every use, please use the cleaning
10
brush to thoroughly brush and blow out
hair on the blades, attachment and the
product.
• Clean the product's exterior surfaces with
a slightly damp cloth and then dry them
thoroughly.
• Make sure that no water enters the
product interior (for example, through
the switch). Keep the product in a dry,
cool location which is protected against
moisture and direct sunlight. Keep this
product out of the reach of children.
IM_KHT200_150617_V04_HR.indb 19
All manuals and user guides at all-guides.com
Warning
Cleaning of the Clipper head
Warning
The charging adaptor should be unplugged
before detaching the clipper head.
The clipper head should be regularly
11
detached and cleaned. Make sure the product
is switched off. Detach the clipper head
by pushing the blade outwards. Brush the
clipper head and the product's interior with
the cleaning brush.
Warning
Do not knock on the clipper head this damage it.
Note
You can rinse the clipper head under water. The
dry it with a soft cloth.
When the clipper head is cleaned and completely
dry, fit the clipper head onto the product. Insert
the tab in the opening of the housing and firmly
press the clipper head until it clicks in.
Lubrication oil
In order to improve the cutting length, apply
12
1-2 drops of the oil onto the cutting head.
This is particularly recommended after
cleaning. Wipe off excess oil with a cloth.
Technical Data
Hair clipper
Rated voltage : 3.6 V
Charging adaptor (MPS005-036100CG)
Rated input : 100 - 240 V~, 50/60 Hz
Rated output : 3.6 V
Battery
Re-chargeable : 2 x 1.2 V
battery Ni-Mh, Type LR6/AA
English
1 A
800 mAh,
19
17/6/15 5:06 PM