Koenic KHT 200 Mode D'emploi page 18

English
Battery operated
Charging the battery
Connect the charging adapter to the DC IN
1
socket on the charging stand and plug the
power adaptor in a suitable power outlet.
Note
Make sure that the groove on the charger plug
match the notch in the charging stand.
Put the product on the charging stand.
2
The LED indicator turns red and shows the
battery is being charged. Ensure that the
product is switched off before charging. The
indicator provides information about the
charging status (20, 40, 60, 80, 100).
LED indicator
During operation the LED indicator shows the
battery level.
LED indicator
Red (stable)
Red (Symbol flashing) < 20% during operation
Red (stable)
Note
You can also charge the product directly via the
charging plug.
Operation via mains adaptor
Ensure that the product is switched off.
3
Connect the charging plug to the terminal
of the product and plug the mains plug
into a suitable socket. The hair clipper is
immediately ready for use.
Note
Make sure that the groove on the charger plug
match the notch in the charging station.
18
IM_KHT200_150617_V04_HR.indb 18
All manuals and user guides at all-guides.com
Battery level
> 20% during operation
Charging battery
Comb attachment and cutting length
With comb attachment
Place the comb attachment on the clipper
4
head and make sure it's engaged on the two
lateral notches on both side of the product.
Set the desired cutting length by sliding the
5
comb attachment.
Cutting length
The default setting on the slide for cutting length
is 0.5 mm. This setting corresponds to the printed
length on the comb attachment. There are more
settings available, please refer to below table.
Position on comb attachment (mm)
4.5 6 7.5
0.5 4.5 6 7.5
1.2 4.8 6.3 7.8
1.9 5.5 7 8.5
2.5 6.1 7.6 9.1 10.6 12.1 13.6
Without comb attachment
Note
Use the hair clipper without comb attachment
for desired hair length of 0.5 mm – 2.5 mm.
Detach carefully the comb attachment from
6
the hair clipper.
Set the desired cutting length. Press down
7
the release button and slide the switch to
the desired position. You can choose the
lengths of 0.5 mm, 1.2 mm, 1.9 mm, 2.5 mm.
9 10.5 12
9 10.5 12
9.3 10.8 12.3
10 11.5 13
17/6/15 5:06 PM