Siemens PA0820M Mode D'emploi page 36

Place the selection box on the operation
function menu using the "up" and "down"
keys (see "Navigation": "up" and "down"
keys).
Use the "+" and "–" keys to move within the
selection box and select the desired function
(see "Navigation": "+" and "–" keys).
Cooling
In this function, the appliance reduces
ambient temperature until the desired
temperature is reached. The appliance
dehumidifies and purifies the air in the room at
the same time in order to create a pleasant
atmosphere.
❏ Plug the appliance into the mains electricity
supply.
❏ Lead the hot air expulsion tube outside,
(see "Preparing the appliance before use").
❏ Check that the plug is fitted onto the water
drainage pipe to prevent water from leaking
onto the support surface.
❏ Lift the air director on the top of the
appliance, Fig. 17.
❏ Turn the appliance on by pressing the "On"
key .
❏ Select the cooling function
"Selecting the operation function").
❏ Select the desired temperature, (see
"Selecting the temperature"). If the
appliance turns itself off automatically
because the desired temperature for the
room has been reached, it will not start
working again until ambient temperature
rises 2-3°C.
❏ Select the operation speed, (see "Selecting
the speed").
All manuals and user guides at all-guides.com
Instructions for Use
Fig. 17
, (see
During air conditioning, the condensed water
produced evaporates automatically and is
expelled outdoors together with the expelled
air through the hot air expulsion tube.
In conditions of extreme humidity, the
appliance accumulates condensed water in the
appliance's rear tank. When a certain level the
appliance beeps twice. The removable tank full
symbol appears on the screen at the same
time to indicate that the tank needs to be
emptied. The appliance stops working when
this happens. To empty the removable tank,
press the handle and remove the tank
carefully. Empty the water down the nearest
drain.
The symbol disappears from the screen when
the water tank has been emptied and replaced
on the appliance properly.
Warning!
When you turn the appliance back on again
after emptying all of the water, do not forget
to replace the removable tank on the
appliance properly. Should you fail to do
so, the symbol will not disappear from the
screen and the appliance will not work.
Remember that when the appliance is
turned off, it is necessary to wait for
approximately 3 minutes before the
compressor starts up again. This period of
time is required in order to ensure correct
appliance operation.
Dehumidification
In this operation function, the appliance
reduces the humidity in the atmosphere. The
appliance purifies the air in the room at the
same time in order to create a pleasant
atmosphere.
❏ Plug the appliance into the mains electricity
supply.
❏ Fit the hot air expulsion tube outside as
indicated in "Preparing the appliance before
use".
❏ Lift the air director on the top of the
appliance.
There are two ways of expelling condensed
water: via the removable tank and in
continuous mode.
36