Belle RANGER 450 Manuel De L'opérateur page 11

NEVER
achieve the required depth of cut.
The saw will then require gentle forward movement to achieve the cut.
The speed of travel will be determined by the condition of the surface being cut.
DO NOT stand in line with the blade and the stream of hot particles whilst sawing.
NEVER plunge the blade harshly into the cut.
If the surface to be cut is very hard, the saw will take longer to cut. Try to make more than one pass as this will reduce otherwise
excessive wear of the blade.
DO NOT try to force the saw forwards as this will cause damage to the blade.
DO NOT
then turn the engine ON/OFF switch to 'O'.
This prevents clogging of the engine with dust and helps to prevent pollution of the atmosphere.
CAUTION
any doubt, Contact your supervisor or Belle Group.
spanners provided.
4. Check the clamping plate and backing plates for damage or wear.
rotation of the tool.
7. Fit a genuine Belle Group blade on to the arbor shaft making certain that
plate.
All manuals and user guides at all-guides.com
Operating Instructions
ALWAYS
Blade Fitment
11
GB
GB