Adjusting The Cutting Angle; Adjusting The Height - ITC SPT240 Manuel Du Propriétaire

ADJUSTING THE MACHINE
ADjUSTING THE CUTTING DEPTH
1. Move the motor base (15, fig.B) as far as possible backwards
2. Set the cutting depth by turning the cutting depth adjustment knob (7, fig.B)
3. Move the motor base forward and check if the pin (A, Fig.B) will fall in the notch
of the adjustment knob.
The following table shows the relationship of the markings on the adjustment knob
to cutting depth, the thickness of material and associated biscuit dowels.
Marking Thickness Of Material
0 8 - 12 mm
10 12 - 15 mm
20 > 15 mm
S -
D -
Max. -

ADjUSTING THE CUTTING ANGLE

The cutting angle can be set by unlocking the clamping lever (8, fig.C) and put

the fence stop (4, fig. C) in the required angle.
Should the clamping lever be in the way when working with the tool, then pull

the clamping lever out and fasten it in a different position without changing the
cutting angle.

ADjUSTING THE HEIGHT

The correct height can be set by unlocking the clamping lever (9, fig.D) and

turning the knob for the height adjustment (10, fig.D) to the desired height with
aid of the scale (11, fig.D).
The height must correspond to half of the material thickness of the working

piece, the groove for the biscuit dowel must always be in the middle of the
working piece.
Should the clamping lever be in the way when working with the tool, then pull

the clamping lever out and fasten it in a different position without changing the
height.
Page 5 of 24
®
Biscuit Size
No. 0
No. 10
No. 20
Simplex
Duplex
-
Cutting Depth
8 mm
10 mm
12.3 mm
13 mm
14.7 mm
18 mm
v.081119