Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
IMPORTANT SAFETY INSTRUCTIONS
ELECTRICAL SAFETY
13.
USE THE RIGHT TOOL. Don't force a small tool or attachment to do the work
of a larger industrial tool. Don't use a tool for a purpose for which it was not
intended.
14.
DRESS PROPERLY. Don't wear loose clothing or jewelry; they can be caught
in moving parts. Protective, non-electrically conductive gloves and non-skid
footwear are recommended when working. Wear protective hair covering to
contain long hair and keep it from harm.
15.
USE EYE PROTECTION. Use a full-face mask if the work you're doing
produces metal filings, dust or wood chips. Goggles are acceptable in other
situations. Wear a clean dust mask if the work involves creating a lot of fine or
coarse dust.
16.
SECURE WORK. Use clamps or a vise to hold the work. It's safer than using
your hands and it frees both hands to operate the tool.
17.
DON'T OVERREACH. Keep proper footing and balance at all times. Do not
reach over or across machines that are running.
18.
MAINTAIN TOOLS WITH CARE. Keep tools sharp and clean for better and
safer performance. Follow instructions for lubricating and safe performance.
Follow instructions for lubricating and changing accessories. Keep handles dry,
clean and free from oil and grease.
19.
AVOID UNINTENTIONAL STARTING. Be sure the switch is in the OFF position
before plugging in.
20.
ALWAYS CHECK AND MAKE SURE TO REMOVE ANY ADJUSTING KEYS
OR WRENCHES before turning the tool on. Left attached, these parts can fly
off a rotating part and result in personal injury.
21.
DO NOT USE THE TOOL IF IT CANNOT BE SWITCHED ON OR OFF. Have
your tool repaired before using it.
22.
DISCONNNECT THE PLUG FROM POWER BEFORE MAKING ANY
ADJUSTMENTS. Changing attachments or accessories can be dangerous if
the tool could accidentally start.
23.
STAY ALERT. Watch what you are doing & use common sense. Don't operate
any tool when you are tired.
24.
CHECK FOR DAMAGED PARTS. Before using this tool, any part that is
damaged should be carefully checked to determine that it will operate properly
and perform its intended function. Check for alignment of moving parts, binding
of moving parts, breakage of parts, mountings, and other conditions that may
affect its operation. Inspect screws and tighten any ones that are loose. Any
part that is damaged should be properly repaired or replaced by an authorized
service center unless otherwise indicated elsewhere in the instruction manual.
Have defective switches replaced by an authorized service center. Don't use
the tool if switch does not turn it on and off properly.
25.
REPLACEMENT PARTS. When servicing, use only identical replacement parts.
26.
SERVICE AND REPAIRS should be made by qualified repair technicians at an
authorized repair centre. Improperly repaired tools could cause serious shock
or injury.
Always check that the power supply corresponds to the voltage on the rating
plate.
Your machine is double insulated. Therefore, no earth wire is required.
Replacing cables or plugs: Immediately throw away old cables or plugs when
they have been replaced by new ones. It is dangerous to insert the plug of a
loose cable in the wall socket.
Using extension cords: Only use an approved extension cable suitable for the
power input of the machine. When using a cable reel always unwind the reel
completely.
Page of 24
®
v.081119
Publicité
Table des Matières
