Fault Signals - Candy CDPM 65720 Mode D'emploi

Memorization of the last
programme used
The last programme used can be memorized
by following the below:
IMPORTANT
The dishwasher must ALWAYS be off
before start of this procedure.
1. Hold down the
SELECTION" button and at the same
time switch on the dishwasher by
pressing the "ON/OFF" button (a brief
audible signal will sound).
2. Keep the "PROGRAMME SELECTION"
button pressed for at least 30 seconds
(during this time, 3 audible signals will
sound).
3. Release the button when the THIRD
audible signal sounds (all the indicator
lights will flash).
4. Press the same button again: the
flashing indicator light (memorization off)
will stop flashing and remain on
(memorization on).
5. Turn off the dishwasher by pressing the
"ON/OFF" button to confirm the new
setting.
To disable the memorization, follow the
same procedure.
All manuals and user guides at all-guides.com
"PROGRAMME
43

Fault signals

If malfunctions or faults occur when a
programme is running the indicator light
that corresponds to the selected cycle
will flash rapidly and the alarm sounds.
In this event, turn the dishwasher off by
pressing the "ON/OFF" button.
After checking to make sure the water
inlet hose tap is open, that the drain
hose is not bent and that the siphon or
filters are not clogged, set the selected
programme again.
If the anomaly persists, contact Customer
Service Department.
IMPORTANT
This dishwasher is equipped with an
anti-overflow safety device which will
automatically discharge any excess
water should a problem occur.
WARNING!
To ensure the correct operation of
the anti-overflow safety device, we
recommend that the dishwasher is
not moved or tilted during operation.
If however it is necessary to tilt or
move the dishwasher, please ensure
that the washing cycle is complete
and that there is no remaining water
inside the dishwasher.