Remote Control - Real Cable HDS-12 Manuel D'utilisation

4.3.

Remote Control

Please remove the battery protection before use.
5. Recommendations of use - troubleshooting
Start-up : it is recommended to switch-on the HDS-12 before the other devices for optimal
operation.
Set-up of the devices : the high performance switching of your HDS-12 allows the source to
auto setup with respect to the display, through the HDMI connection. Depending on the devices
connected, this auto setup may take some time and when you select a source you may have to
wait a few seconds before having a picture on the screen. This is a normal behavior.
Nevertheless, with some device, the auto setup may take too much time or will not establish. In
this case, it is recommended to disable the automatic setup in the source and set a picture
resolution (starting with 720p) and a sound format (starting with PCM stereo) compatible with
the display (see their corresponding manuals).
In case of operation troubles : check the cable's connections, switch off all your devices,
disconnect the HDS-12 power supply, wait 10 seconds, reconnect, switch ON the HDS-12,
then one of the displays, wait for complete start up of it, then switch ON the source.
6. Specifications
Bandwidth : 2.25 Gbps (single link) per color, 6.75 Gbps total
Max Pixel Rate : 225 MHz
Input : 1 x HDMI female (type A)
Outputs : 2 x HDMI female (type A)
5 V DC (1 A) universal power supply included
24K gold plated connector
Weight : 380 g
Dimension (W x D x H) : 142 x 93 x 38 mm
1. Power : press the button to turn on/off the
HDS-12.
2. Optimize : press the button to turn on/off the
optimize function.
3. Direct output selector : press 1 or 2 to select
the corresponding output display.
4. Battery type : 3 V CR2025 lithium.
6/12
Real Cable ®