Front Panel; Rear Panel - Real Cable HDS-12 Manuel D'utilisation

4. Operation
4.1.

Front Panel

1. Remote control sensor.
2. Output select – Indicators : press the "Select" button sequentially to switch to your desired output
display. The LED will illuminate to indicate which Output display is selected.
3. Signal optimizing – Indicator : press the "Optimize" button to improve signal quality after long
distance transmission, press again to turn off. The LED is illuminated when the signal is optimized.
4. Power button – LED indicator : the "ON" LED will illuminate when the power is connected, the
LED will turn off when the unit is switched off by the remote control or the button.
At first start-up, Output 1 is selected by default, afterward the last selected output is memorized.
4.2.

Rear Panel

1. HDMI Outputs : connect the HDMI "Output 1 and 2" of the unit to the HDMI input of your
displays using HDMI cables.
2. HDMI Input : connect your HDMI source to the HDMI "input " of the unit using an HDMI cable.
3. Power Inlet : plug the supplied 5 V DC (1 A) power supply into the unit.
1
2
1
5/12
3 4
2 3
Real Cable ®