Asist AE7V160-25FS Mode D'emploi page 41

Switching on and off
Put the paper bag in the container.
Make sure it is installed correctly.
Place the upper part on the container and secure with
clips.
Connect the fl exible hose with the suction tubes fi tted
to the suction opening. Select a suitable attachment
according to the type of work and place it on the
suction tube.
Insert the vacuum cleaner plug into the el. socket and
press the switch to position „I". The vacuum cleaner
will work independently.
To switch off the vacuum cleaner, set the switch to the
‚0' position.
The vacuum cleaner is equipped with the „SYN-
CHRO" mode
Plug the power tool into the built - in socket on the
vacuum cleaner / max. 2000W /. Set the vacuum
switch to position ‚II'. After you turn on the power tool,
the vacuum cleaner starts automatically. When you
switch off the power tool, the vacuum cleaner also
switches off with a short delay.
CAUTION: Always unplug before cleaning or mainte-
nance.
Dry vacuuming
For dry vacuuming, insert a dust fi lter in the vacuum
cleaner container.
Place the upper part on the container and secure with
clips.
Connect the fl exible hose with the suction tubes fi tted
to the suction opening. Select a suitable attachment
according to the type of work and place it on the
suction tube.
Insert the vacuum cleaner plug into the el. socket and
press the switch to position „I". The vacuum cleaner
will work independently.
Wet vacuuming
Attention!
The dust fi lter is only suitable for dry vacuuming,
never wet.
Place the supplied foam fi lter on the fi lter basket.
Place the upper part on the container and secure with
clips.
Proceed as described in the „Dry vacuuming" section.
After use
Press the power key to the ‚0' position to turn off the
device.
Unplug the power cord.
Wind the power cord.
Disconnect the suction tube from the device. Remove
the main part.
If it is full, remove the paper bag. Put a new paper
bag in the container.
Assemble the vacuum cleaner and secure the clips.
Filter cleaning function
Clog the suction tube with one hand, press the knob
button repeatedly with the other.
The air stream passes through the space in the cover
and enters the fi lter to shake off the dust.
Blowing function
Insert the suction hose as deep as possible into the
air outlet hole at the top of the engine cover and
secure
by turning it clockwise. Please check the correct
direction according to the arrow in the picture.
(Release it by turning it counterclockwise and pull it
out). If the vacuum cleaner is on, you can suck
use for blowing dust, blowing leaves, etc.
41