KTM Power Parts 51539974000 Mode D'emploi page 8

2
4
8
- Lay the map cable switch towards the rear to the motor control selector
2
switch (2).
- Connect the map switch cable (1b) to the motor control selector switch
(2) and to the vehicle wiring harness (4).
1b
Route the cable neatly and without bends and tie it with cable binders. Ensure
that the handlebar can turn all the way.
Final steps
- Mount the headlight mask (see Owner's Manual, LC4 only).
- Mount the tank (see Owner's Manual; not for 690 SMC and 690 Enduro).
- Mount the seat (see the Owner's Manual).
Adjustments, 2-stroke
Map switch (Figure A):
Pos. 1 ->
Pos. 2 ->
Adjustments, 4-stroke LC4
Map switch (Figure A):
Pos. 1 ->
Pos. 2 ->
A
Motor control selector switch (Figure B):
Pos. 1 =
Pos. 2 =
Pos. 3, 4, 5, 6, 7, 8, 9, 0 = Standard
NOTE:
If the ignition timing map is changed during a ride, it is not activated imme-
diately. The selected ignition timing map does not go into effect until the
motorcycle is at idle speed and the throttle is closed.
Spare parts:
Map switch cable 4-stroke
Map switch cable 2-stroke
B
Motor control selector switch
Performance ignition timing map (height performance).
Soft ignition timing map (gentle power development).
Standard ignition timing map.
Previously selected ignition timing map on motor control
selector switch
Wet condition (gentle power development)
Advanced (aggressive power development)
77239974050
51539974050
76511010000