Veiligheidsvoorschriften - TVC Tovenco Pinotage Notice D'utilisation

left running for 15 minutes after the food is cooked, in order
to thoroughly eliminate all contaminated air. The effective
performance of the cooker hood depends on constant main-
tenance; the anti-grease filter and the active carbon filter both
require special attention.
• The anti-grease filter is responsible retaining the grease
particles suspended in the air, therefore it is subject to clogging
with variable frequency according to the use of the appliance.
- To prevent the danger of possible fires, at least every 2
months one must wash the anti-grease filters by hand using
non-abrasive neutral liquid detergents or in the dishwasher
at low temperatures and on short cycles.
- After a few washes, colour alterations may occur. This does
not give the right to claim their replacement.
• Before remounting the anti-grease filters and the regen-
erable active charcoal filters it is important that they are
completely dry.
• Clean the hood frequently, both internally and externally,
using a cloth dampened with denatured alcohol or neutral
liquid detergents that are non abrasive.
• The lighting .system is designed for use during cooking
and not for the prolonged general lighting of the room. The
prolonged use of the lighting system significantly decreases
the average duration of the bulbs.
• If the appliance is equipped with courtesy lights it is possible
to use them for general room lighting for a prolonged amount
of time.
• Attention: the non compliance with the hood cleaning
warnings and with the replacement and cleaning of the filters
entails risk of fires. One therefore recommends keeping to the
suggested instructions.
• Replacing halogen light bulbs (Fig.9):
To replace the halogen lamps, B push the watch glass C and
open the flap. Replace them with a light of the same type.
Attention: Do not touch the lights with your hands.
If the appliance version includes LED lamps, the intervention of
a specialised technician is necessary to replace them.
• Commands (Fig.10):
NOTE: All units' functions are controlled through a remote
control.
If the remote control stops functioning (because of low
batteries, etc.) you can directly use the control inside the
unit (Fig. 8-10).
Power Button (A) = The on/off button switches on and off the
whole hood (motor and lights).
By pressing the button the motor starts at 1st speed.
Fan Speed button (B) = From the OFF position, press once
for the 1st speed, twice for the 2nd speed and three times for
the 3rd speed. In order to activate the intensive speed, press
the button for 5 seconds regardless of the status of the hood.
For each speed only the led indicating the set speed will turn
on. The intensive speed is indicated by the flashing of the led
indicating speed 3. The duration of the intensive speed is 10 mi-
nutes; after this time the hood goes back to the last set speed.
In order to remove the intensive speed press the power button
and the hood will switch off, or press the Fan speed button and
the speed goes back to the previously set one. Speed of the
hood with cyclic trend.
Light button (C) = There are three light levels: High, medium,
low.
From the off position press once for the high level, twice for
the medium level, three times for the low level and four times
to turn the lights off.
The level of the lights has a cyclic trend: High, medium, low, off.
Timer button (D) = With any type of speed (excluding the
All manuals and user guides at all-guides.com
intensive speed), by pressing the button, the timer function is
activated for 15 minutes. After this time has elapsed the hood
will turn off (motor and any light on).
Lights indicator (E) = The lights indicator will switch on when
the lights are on at any level.
Filters indicator (F) = After 30 minutes of operation, the led of
the filters indicator will switch on, not flashing indicating that
the anti-grease filters have to be washed. To reset the function
(with the hood off ), press the Fan speed button for 5 seconds.
After this operation, the led of the filters indicator turns off and
the setting of the 30 hours starts again from the beginning.
Clean air indicator (8).
With the hood off, press the Power button (1) for 5 seconds to
activate the clean air function. This will switch on the motor
at speed 1 for 10 minutes every hour. The light indicator will
switch on without flashing and the led of the 1st speed will
switch on. In the remaining 50 minutes the light indicator will
flash. The function can be deactivated by pressing any button
except for the lights one.
THE MANUFACTURER DECLINES ALL RESPONSIBILITY
FOR EVENTUAL DAMAGES CAUSED BY BREACHING THE
ABOVE WARNINGS.
ALGEMEEN
De inhoud van dit boekje grondig doorlezen, daar het
belangrijke informatie bevat voor veilige installatie, gebruik
en onderhoud. Het boekje bewaren voor verdere raadpleging.
Het toestel werd ontworpen voor gebruik in een aanzuigversie
(evacuatie lucht naar buiten - Fig.1B) of met remote motor (Fig.1A).

VEILIGHEIDSVOORSCHRIFTEN

1. Opletten indien tegelijkertijd een afzuigkap en een brander
of haard functioneren die afhankelijk zijn van de omgevings-
lucht en gevoed worden door een andere energiebron dan de
elektrische energie. De afzuigkap kan de lucht die de brander
of haard nodig heeft voor de verbranding aan de omgeving
onttrekken. De negatieve druk in de omgeving mag niet boven
de 4 Pa (4x10-5 bar) liggen. Voor een veilige werking dient u te
zorgen voor een goede ventilatie van de ruimte. Voor de afvoer
naar buiten moet u zich houden aan de geldende voorschriften
die van toepassing zijn in uw land.
Voordat u het model op het elektriciteitsnet aansluit:
- Controleer op het gegevensplaatje (aan de binnenkant van
het apparaat) of de spanning en het vermogen overeenko-
men met die van het net, en of de stekker geschikt is voor
de aansluiting. Neem in geval van twijfel contact op met een
gekwalificeerde elektricien.
- Als de voedingskabel beschadigd is dient deze te worden
vervangen door een andere kabel of een speciale kabel-
combinatie, beschikbaar bij de fabrikant of de technische
servicedienst.
- Verbind het mechanisme aan de voeding m.b.v. en stekker
met zekering 3A of aan de twee draden van de tweefase
beschermd met een 3A zekering.
2. Attentie!
In bepaalde omstandigheden kunnen huishoudelijke ap-
paraten gevaarlijk zijn.
A) Probeer niet om de filters te controleren terwijl de
- 14 -
NEDERLANDS
NL