Setting The Remote Control - Philips SRU 510/86 Mode D'emploi

SRU510_86_v6.qxd 26-04-2005 14:10 Pagina 5
All manuals and user guides at all-guides.com

Setting the remote control

This is only necessary if your TV does not respond to the SRU510.
If that is the case, the SRU510 does not recognize the brand and/or model of
your TV and you need to program the remote control to do so.
You can set the remote control either automatically or manually.
Automatically setting the remote control
The remote control will now automatically search for the right code for your
device.
1
Make sure the TV is switched on and select a channel using the original
remote control or the keys on the TV (for example channel 1).
The SRU510 emits the 'switch off TV' signal for all models of TV that are
stored in the memory.
2
Then keep keys 1 and 3 on the SRU510
pressed simultaneously for three seconds,
until the LED flashes twice and then remains lit.
3
Press and hold the Standby key
of the SRU510.
– The SRU510 now starts emitting all known
'TV off ' signals, one by one.
Each time a code is sent, the LED
lights up
4
When your TV switches off (stand-by), release the Standby key of the
SRU510 immediately.
– The SRU510 has now found a code that works on your TV.
5
Check if you can operate all functions on your TV with the SRU510.
• If this is not the case, you can redo the automatic setting.
The SRU510 will then search for a code that works better.
– After the SRU510 has run through all the known codes,
the search will stop automatically and the LED will stop flashing.
– Automatic programming of a TV takes a maximum of 5 minutes.
Instructions for use
5