Casada SKYLINER A300 Mode D'emploi page 17

Putting the chair into use
STARTING THE MASSAGE
1) Connect the remote control to the chair (CONTROLLER JACK). Then connect the mas-
sage chair to the power supply system. To do this, connect the power cable supplied with the
socket and the chair (POWER INPUT). The connections are located at the bottom part of the
back of the device (see following illustration). Now turn the main switch to the ON position.
Connection procedures
2) Press the power button on the remote control. The chair automatically moves to the preset position.
3) The chair now automatically starts to scan your body shape and shoulder height. Once this is finished (re-
mote control starts to beep), you can select your automatic programme. If you do not make a selection,
the "Comfort" programme starts automatically.
4) If the shoulder position detected deviates from the actual shoulder height, this can be manually set using
the „Up" – or „Down" button (see illustration).
Keys on the remote
Description
control
This moves the massage heads upwards.
Shoulder position
Alignment (upper button)
This moves the massage heads downwards.
Shoulder position
Alignment (lower button)
5) During scanning of the shoulder height, you can directly select a previously stored massage programme
M1 or M2 (Memory Function). This way the scanning is directly terminated and the chair starts the
memory programme.
PROGRAM MEMORY
6) If you do not require an automatic programme, you can of course switch to manual mode.
32
Shut off power and finish massage
Press power button during massage to stop all massage functions immediately or
one setting massage program finished, backrest and footrest won't return to
original position, and the remote controller display
twinkle.
A.Press M1 or M2 button within 10 seconds to store the massage mode.
B.Or press the power button Within 10 seconds, the massage hands, backrest and
footrest will return to original position automatically.
C.Or waiting for 10 seconds , the massage hands return to original position ,but
F US E ON/OF F TOUC H S C R E E N
P OWE R INP UT C ONT R OLLE R J AC K
Turn off power
Figure (Cut off the power of the machine)
Electrical power switch
Diagram of the switch position of power supply
Instruction manual
Display
when release it.
Calf rest decline button: press this button, calf rest decline slowly, stop
when release it.
Putting the chair into use
Backrest lifting button: press this button, back rest lifting slowly, stop
when release it.
Backrest decline button: press this button, back rest decline slowly, stop
when release it.
FINISHING THE MASSAGE
If you press the power button prematurely during the massage or if the defined massage time has been SA & Memory
reached, all massage functions are ended immediately. However, the footrest and the backrest remain in
their end position.
Now a "SA" symbol is displayed on the controller
and the "Memory" symbol flashes.
A. Press M1 or M2 within 10 seconds in order to save the settings of the previous massage.
B. If you press the power button again within 10 seconds, the massage heads, the backrest and the foot-
rest return to their starting position.
TOUCH SCREEN
FUSE ON/OFF
POWER INPUT CONTROLLER JACK
Method of turn off power
C. If you do not perform any action within the 10 seconds, the massage heads automatically return to their
starting position. Footrest and backrest remain in the final position.
1
2
3
4
5
6
Description Description
Number Number
function keys
1 7 status-bar
massage status information display area Service
2 8
3 upper body intensity adjustment 9 operation/pause key
massage button function setting function
4 10
long press for 2 seconds to exit program information prompt line
5 11
minimize program
6
Preparation before operation
1)Installation program download and install
Installation program supplied by agent or download from the network provide by agent .
Instruction manual
9
10
11
33