REVAMP Professional LIBERATE ST-1700 Mode D'emploi page 3

lower heat settings. If you have thick or coarse hair, use the higher heat settings.
• The selected digital temperature display will flash until the straightener has reached
the temperature wanted. Once the temperature has been reached the white LED light
will remain static.
• Working on one section at a time run the straightener through the entire length of
the hair from roots to ends, without stopping. Use a comb while straightening for even
straighter results.
• Repeat this process all over the head, allowing hair to cool before combing through.
• After using the straightener, switch off, unplug, place on heat resistant surface and
allow to cool before storing away
• For extra safety and ease of storing, lock the plates together and place the device in
the heat resistant travel pouch as shown in the Features section. Let the straightener
cool down before placing it into the heat resistant travel pouch.
• IMPORTANT! When using the straightener, take care not to place it too close to face,
ears, neck or skin.
Follow us on www.revamphair.com for the latest hair tips and advice.
Please note:
• Repeat only twice per section to prevent hair damage.
• This is a high-performance product, avoid frequent use to prevent hair damage.
• Regular use of styling products may deteriorate the surface coating over time.
• Do not scratch the surface of the product as this will deteriorate the effectiveness of
the coating.
• While heating, during use and cooling, place on heat resistant surface or on top of the
REVAMP heat-resistant travel pouch. Only hold unit by the handle.
• The product reaches a very high temperature during operation, please style with
caution when using. Make sure to keep away from the scalp and skin to avoid burns.
CHARGING YOUR LIBERATE CORDLESS STRAIGHTENER
You must recharge your Liberate Cordless straightener when it runs out of charge by using
the UK/EU adaptor provide in the box with the straightener. The charging time should be
of 3 hours from empty for approximately 30 minutes use according to the temperature
setting selected.
Please follow the instructions illustrated below to use the adaptor and charging cable:
Whilst charging, the blue LED light of your straightener, indicating the battery level of the
device, will flash slowly and continuously. There are 4 blue LED lights on your straightener
that indicates the level of battery charged.
1st LED light
2nd LED light
3rd LED light
4th LED light
Once the blue LED light becomes static, this means the battery is charged to the level
indicated above.
from 0% to 25%
from 25% to 50%
from 50% to 75%
from 75% to 100%