AKO WW 101 E Instructions De Montage Et D'utilisation page 7

ATTENTION!
Depending on the size of the room, heat requirement
and thermostat setting, rooms may overheat if the
heating is not controlled. This can be dangerous for
people who are not able to leave the room as it gets too
hot!
5. Protection Against Overheating
If the permissible temperature is exceeded, the heating
device switches off automatically. If this occurs, discon-
nect the mains plug and leave the device unplugged for
a few minutes, so that the temperature limiter can
switch back again.
Then rectify the cause e.g. when the air grid is blocked
or covered. When the device has cooled sufficiently, it
can be started up again.
6. Faults
If the heating device is not emitting heat, check the fol-
lowing points:
Is the power switch in the ON position?
Has the thermostat been set to the desired temper-
ature?
Has the overheat protection been triggered? See
chapter 5!
Is the fuse in the fuse box switched on?
If you cannot remedy the fault, please contact your
electrical retailer. If required, you can also contact the
service hotline of Glen Dimplex Deutschland GmbH.
Tel.: +49 (0) 9221 709-564
Fax: +49 (0) 9221 709-589
To process your order, please state the device type as
well as its production number (E Nr.) and manufactur-
ing date (FD). This information can be found on the
type plate.
Repairs and corrective measures may only be carried
out by a qualified electrician or your after-sales service.
Glen Dimplex Deutschland GmbH
Am Goldenen Feld 18
D-95326 Kulmbach
Subject to modifications without prior notice
www.dimplex.de/en
All manuals and user guides at all-guides.com
ww1e-gb-ba · 11/14/B
7. Cleaning
To clean the device, first disconnect it from the mains
and allow it to cool down. Clean the outside of the unit
using a soft, damp cloth. Do not use scouring powder
or furniture polish as these may damage the surface.
Dust which gathers inside the device can be removed
from the outside using a vacuum cleaner.
8. Technical Data
Model WW 101 E
Nominal power 1000 W
Dimensions
635 x 468 x
wall mounted
140 mm
(W x H x D)
Dimensions
635 x 500 x
free-standing
275 mm
(W x H x D)
Weight 4.7 kg
Connection
voltage
Degree of pro-
IP24 (splash protection)
tection
Protection
II (with protective insulation)
class
9. Warranty
This product is supplied with a two-year warranty ac-
cording to our terms of guarantee.
10. Note on Disposal
Do not dispose of the device with general
household waste. The device must be taken to
a local waste disposal plant.
Phone number: +49 9221 709 564
Fax: +49 9221 709 589
E-Mail: 09221709589@dimplex.de
www.dimplex.de/en
WW 101 E - WW 201 E
WW 151 E WW 201 E
1500 W 2000 W
835 x 468 x 1035 x 468
140 mm x 140 mm
835 x 545 x 1035 x 545
275 mm x 275 mm
6.0 kg 7.4 kg
1/N 230-240V~
EN-7