Baninni ROADTRIP Mode D'emploi page 19

Fastening the safety seat buckle.
STEP 1
Step 1. Slot the two metal sections of the buckle connectors together.
Step 2. Slot the two buckle connectors into the slots in the top of the buckle
until they click into place.
Step 3. Always check the harness is correctly locked by pulling the shoulder
straps upwards.
To release the harness, press the red button on the buckle downwards.
Tighten the harness
All manuals and user guides at all-guides.com
STEP 2
Pull the schoulder straps upwards to remove the lack from the
lap sections of the harness then pull the adjuster strap until the
harness is fully tightened.
The harness should be adjusted as tightly as possible without
causing discomfort to your child.
Ensure that the lap strap portion of the harness is located as
low as possible towards the thighs -not around the tummy.
A loose harness can be dangerous. Check the harness
adjustment and tighten each time the child is placed in the
seat.
The harness is loosened by pressing the lever (unde rthe
seat cover) on the front of the seat;
Press down on the label marked 'Press' as you grip the two
shoulder straps with your other hand. Pull the schoulder
straps towards you to loosen the harness.
Take care when you adjusted the shoulder straps that you
do not trap the harness adjuster straps as you press the
lever down.
STEP 3