Battery Charge Indicator - The Fountainhead Group 183435 Manuel D'utilisation Et D'entretien

Masquer les pouces

Table Des Matières

Table des Matières

Les langues disponibles

OPERATING INSTRUCTIONS CONTINUED

Flow Rate and Pressure:

Sprayer flow rates are typically measured in gallons per minute (gpm) or liters per minute (lpm). As with

any electric pump, the spraying pressure and flow rate are determined by a combination of the pump

performance and nozzle characteristics. Pressure and flow rates can be changed by using different

nozzles. This Sprayer contains a pump that is optimized to spray 0.2 gpm at a pressure of 40psi, but is

capable of a wide range of pressures and flow rates with little change in Battery life. Pressure and flow

rate will vary depending on actual nozzle used. It is the responsibility of the user to select an appropri-

ate nozzle for the desired application.

Some sprayers are equipped with a flow adjustment controller, located near the Power Switch, which

allows the user to adjust the Pump performance to meet a desired flow rate or spray pattern intensity.

This range of flow rate and spray pattern intensity will vary, depending on performance of nozzle being

used.

Determining Actual Flow Rate:

Typical flow rates for this Sprayer range from 0.15 gpm (0.57 lpm) to 0.3gpm (1.13 lpm). The actual flow

rate for any nozzle can be measured by spraying into a suitable container for 1 minute, then measuring

the volume of liquid (in gallons or liters) in the container. This amount is equal to the flow rate (gpm or

lpm).