2�2 Safety Instructions For Backup Camera Installation - Carbest 47349 Mode D'emploi

GB
• Do not use the cable to carry or pull on the camera or transmitter�
• Powering the backup camera system requires an input voltage of 12 V / DC� Always
disconnect the monitor from the power source by unplugging the 12 V plug when not in use�
Never pull on the connector cable to disconnect!
• Never allow liquids to enter the monitor! Never immerse the monitor in liquids! Only operate
the monitor dry�
• The camera is protected against rain but not waterproof! Do not immerse camera in water or
other liquids!
• Be sure all plugs and power cables are dry� Never power on the equipment with moist or wet
hands!
• The backup camera system may interfere with other cordless equipment (e�g� mobile phones,
Bluetooth equipment) during use or receive interference� Thus, do not use such equipment
near the backup camera system or this system near other wireless equipment�
• Extreme high or low temperatures or rapid temperature changes may cause the camera to not
function properly or cause the monitor to not show objects correctly�
• Bright light hitting the camera lens directly may result in objects being overexposed and not
being displayed clearly�
• After using a car wash, the camera's detection range may change due to mechanical effects�
Be sure to check for this and readjust the camera if necessary
2.2 SAFETY INSTRUCTIONS FOR BACKUP CAMERA INSTALLATION
• Before installing the backup camera system and before each functionality test of the backup
camera system, secure the vehicle to prevent it from rolling away� Attention – risk of injury and
property damage! Always engage the hand brake and shift into gear! Automatic transmissions
must be put into Park and the hand brake engaged!
• Do not run or start the vehicle while installing the backup camera system!
• Always follow safety instructions if the vehicle is on jacks or a car lift or the like!
• Caution! Risk of electrical voltage near the spark coils, distributor cap, ignition
cables, spark plugs and electrical components inside the vehicle!
• Follow the automaker's safety instructions and manual!
• Only install the backup camera system in a safe environment! Keep clothing, hair, limbs and
the backup camera system away from moving and hot engine- and car parts!
• During installation be sure cables are securely and tightly mounted� Do not mount these to
conductive materials� If cables are run through walls with sharp edges (metal sheets, etc�)
use ductwork or conduit to prevent cable damage� Protect cables from damage, do not bend�
Immediately replace damaged cables!
• Risk of short circuits! Verify the correct polarity when connecting the camera cable to the
vehicle power� Refer to the manual for notices and the automaker's wiring diagram�
• When installing the backup camera system always be sure the safety and functionality of other
systems and equipment in the vehicle is not impaired! Please follow the instructions of the
automaker's manual�
Backup Camera System RV 4.3 | 47349
26