Setting Datashur Bt As Read-Only; Brute Force Hacking Detection - iStorage DATASHUR BT Manuel D'utilisation

14. Setting datAshur BT as Read-Only

Your datAshur BT can be set as Read-Only (Write-Protected).
To set as Read-Only, first unlock your datAshur BT as described in section 8. Once the drive is unlocked
showing a GREEN padlock ( ) on the App and solid
How to set as Read-Only
1. Tap on the GREEN
2. Tap the Read-Only switch to
on the 'Notification' screen, tap LOCK.
Note: The drive will lock. Next time the drive is
unlocked access will be restricted to Read-Only.
3. To disable (turn off) Read-Only tap the
switch Off.
Note: The drive will lock. Next time the drive is
unlocked access will be back to Read/Write.
Note: Read-Only may have been preset by your Administrator, if so, you will be unable to change this setting. Contact your
Administrator for further information.

15. Brute Force Hacking Detection

If an incorrect password is entered 10 (ten) consecutive times, the datAshur BT's brute force mechanism will trigger and the
encryption key, all data and credentials will be deleted and lost forever.
If your datAshur BT drive has been brute forced, it will need to be provisioned by your Administrator before it can be used
again.
#14
padlock.
ON and
Blue ( ) LED on your datAshur BT, proceed with the following steps.
App
www.istorage-uk.com
Drive LED