Installation And Operation; Safety Instructions - Bartscher TOP POWER Mode D'emploi

5. Installation and operation

5.1 Safety instructions

WARNING! Electrical hazard!
The device must only be connected to a properly installed single socket with
protective contact.
Never yank cord to disconnect from outlet.
Cable must not touch any hot parts.
•
See that the cable does not touch any heat sources or sharp edges. Do not let the
cable dangle over the counter edge.
•
Do not use the device in case it does not function properly, has been damaged or
dropped.
•
Do not use any accessory or spare parts that have not been recommended by the
manufacturer. These can be dangerous for the user or lead to damages of the
device or personal injury, and further, the warranty expires.
•
Do not lay the cable over carpets or heat insulations. Do not cover the cable. Keep
away the cable from operating range and do not dunk it into water.
•
Do not move or tilt the device when in operation.
WARNING! Hazard via electrical current!
The device can cause injuries due to improper installation!
Before installation the local power grid specification should be compared with
that of the device (see type label).
Connect the device only in case of compliance! Take note of the security advice!
•
It is extremely important to not damage the door and that it can be closed properly.
Example of damage to the door which may be unsafe include the following:
1. warping and indentations,
2. cracked and/or properly secured hinges and screws,
3. damaged door seals,
4. cracked glass pane,
5. damaged locking elements.
•
The space between the door and the device must be free of foreign objects.
•
Door seals must be tight and clean, as dirt and damage may allow electromagnetic
waves to escape from the microwave oven. Take care to prevent buildup of any
residues (e.g. cleaning agents, dust, grease, etc.).
All manuals and user guides at all-guides.com
- 29 -