Product Guarantee; Maintenance And Cleaning - Novellini Calos Notice D'installation, Utilisation Et Entretien

INTRODUCTION:
Whirlpool baths must be installed by trained personnel able to
demonstrate to the relevant authorities their knowledge and
ability in the application of health and safety regulations, i.e.
electricity and water supplies and waste water disposal. The
manufacturer provides training for technical assistance staff and
therefore you are advised to contact an authorised technical
assistance centre for the purposes of installation.
This symbol is used throughout this manual to indicate
important instructions or important safety information
about the product.
INSTALLATION:
IMPORTANT!
IMPORTANT!
Before starting to assemble and install the product, carefully read
through all the instructions. Unpack the components and check
that nothing is missing and that there are no damaged or faulty
components; remove the transparent protective film, where
present.
N.B.: This product is designed for installation on finished walls
and floors.
For all warranty claims, the purchase invoice/receipt must be
produced along with the product assembly instructions.
The drawings and illustrations in this manual are provided for
information purposes only.
The manufacturer reserves the right to make changes and
improvements.
INSTALLATION OF BATH WITH FRAME:
Follow the sequence of drawings given in this manual very
carefully when installing a bath with frame.
FITTINGS (optional):
A pack of finishing profiles can be ordered on request, which are
easy to install and make the joint between the wall and the edge
of the bath both aesthetically elegant and functional (please
contact your retailer). These profiles are suitable for use on baths
of any size.

MAINTENANCE AND CLEANING:

The bath is made of acrylic and must be cleaned using a liquid
detergent and a soft cloth or sponge. Use a good quality
household liquid detergent. To prevent scale deposits, wipe dry
using a chammy leather or a soft lint-free cloth that removes
stubborn deposits without leaving traces. Limescale deposits
may be removed using specific detergent products. To restore
shine to the acrylic surface polish with an ordinary wax polish
such as for car bodywork.
DO NOT USE ABRASIVE CLEANERS, ALCOHOL OR ALCOHOL-
BASED PRODUCTS, ACETONE OR OTHER SOLVENTS.
Warning: use of detergents other than those recommended
may damage the bath and/or the whirlpool equipment.
SURFACE SCRATCHES:
Small surface scratches can be removed using wet emery paper
(grade 1000) and then smoothing the surface with abrasive
paste. Once the scratch has been removed, restore surface shine
using wax polish.
DISPOSING OF THE WHIRPOOL BATH:
For the disposal of the product or its parts, follow the local
regulations on matters of waste disposal. For Italy, Legislative
Decree n. 152 of April 3, 2006 will hold, and for the other EU
countries, Directive 2008/98/EC.

PRODUCT GUARANTEE:

All products purchased by consumers, as defined in Article 3 of
the Consumer Code (Legislative Decree no. 206 of 6 September
2005 and subsequent amendments), are covered by the legal
guarantee of the seller under Article 128 and subsequent
amendments of the consumer Code. In case of lack of conformity
of the product, we invite the consumer to contact their dealer
within the statutory deadline.
15
ENGLISH
Romanore di Borgo Virgilio, lì 01.01.2015
Novellini S.p.a.
Marco Novellini
Amministratore delegato