Bottom Plate; Finishing The Installation - AirKing Profesional Serie Manuel D'utilisation

5. Plug both the 3 wire and 4 wire quick connect cords from the blower
into the appropriate receptacles located on the inside front of the hood
canopy. These cords will only fit into the receptacles one way (Figure 3).
6. Reinstall the rear bottom plate by fitting the back edge of the plate into
the channel located on the back of the hood and reinstalling the two
nuts and washers removed in Step 1 (Figure 5).

Bottom Plate

Figure 5
SECTION 4

Finishing the Installation

1. Install the included fuse into the electrical panel by turning the fuse cap
counter clockwise and pulling out. Insert the included 1/4" x 1-1/4"
time delay fuse in the holder and reinstall into the panel (Figure 6).
672016 Rev. H 12-18
Nut
Washer
Cap
Figure 6
NOTE: If you need to replace the fuse, replace with a 1/4" x 1-1/4"
Bussman MDA-3 or equivalent 3 amp, 250V ceramic, time delay fuse only.
2. Refer to the hood instruction manual to complete the installation, for
maintenance, and before restoring power.
3. The blower is covered under the range hood's warranty.
www.airkinglimited.com
Fuse
3 of 8