Installation Instructions; Preparing For Installation - AirKing Profesional Serie Manuel D'utilisation

INSTALLATION INSTRUCTIONS

CAUTION:
AT SERVICE PANEL BEFORE STARTING INSTALLATION.
WARNING:
THIS BLOWER IS INTENDED FOR USE ONLY
IN AIR KING PROFESSIONAL SERIES RANGEHOOD CANOPIES
MARKED SUITABLE FOR USE WITH THIS BLOWER. DO NOT INSTALL IN
ANY OTHER APPLICATION.
SECTION 1

Preparing for installation

NOTE: Before installing blower, make sure range hood canopy is properly
installed and securely in place. See "Range Hood Mounting Instructions".
1. Unpack blower from the carton and confirm that all pieces are present.
In addition to the blower you should have:
8 - #8-32 Screws
8 - Flat Washers
8 - Star Washers
2 - #10-32 Serrated Flange Nuts
1 - Fuse
1 - Capcitor Cover
2 - #6 Screws
1 - Instruction/Safety Sheet
2. Position the capacitor cover over the two holes in the blower housing
& attach using the two #6 screws provided (Figure 1).
Figure 1
3. The installation of the blower is slightly different from one canopy
height to another. For 18" high canopies proceed to Section 2, for 10"
high canopies proceed to Section 3.
SECTION 2
Installation into 18" High Canopy
1. Loosely install the two #10-32 serrated flange nuts (included) onto the
studs located inside the top center of the hood.
2. Lift blower up into the hood canopy and slide the keyhole slots in the
motor mounting flange over the two studs of the hood. Slide the motor
into place and tighten the hex nuts on the mounting stud while lining
up the 8 holes in the motor mounting flange to the 8 screw studs of the
hood (Figure 2).
672016 Rev. H 12-18
MAKE SURE POWER IS SWITCHED OFF
Figure 2
3. Using 8 of the included #8-32 screws, flat washers and star washers,
mount the blower in place and tighten all screws. Confirm that the
blower is securely seated in place and there are no air gaps around the
blower gasket.
4. Plug the 2, 3 wire and 4 wire quick connect cords from the blower
into the appropriate receptacles located on the inside front of the hood
canopy. These cords will only fit into the receptacles one way (Figure 3).
Figure 3
SECTION 3
Installation into 10" High Canopy
1. Remove the rear bottom plate of the hood canopy. It is secured in place
with a nut and washer on either side (Figure 4).
Bottom Plate
Figure 4
2. Loosely install the two #10-32 serrated flange nuts (included) onto the
studs located inside the top center of the hood.
3. Lift blower up into the hood canopy and slide the keyhole slots in
the blower mounting flange over the two studs of the hood. Slide the
blower into place and tighten the hex nuts on the mounting stud while
lining up the 8 holes in the blower mounting flange to the 8 screw
studs of the hood (Figure 2).
4. Using 8 of the included #8-32 screws, flat washers and star washers,
mount the blower in place and tighten all screws. Confirm that the
blower is securely seated in place and there are no air gaps around the
blower gasket.
www.airkinglimited.com
Stud w/Hex Nuts
Screw Stud
Keyholes
Receptacles
Wire Harness
Blower
Nut
Washer
2 of 8