TallyGenicom 9045N Guide De Démarrage Rapide page 24

Chapter 2 Setting Up Your Printer
Setting an IP address manually
20
All manuals and user guides at all-guides.com
If you require to set an IP address manually into the printer, as opposed to letting
the printer receive one from a DHCP source, then you have to ensure that
DHCP is switched off. Use the following procedure to switch DHCP off.
1 Press the MENU button on the control panel.
2 Press the NEXT button until the text
"Interface Menu" is shown on the second
line of the display.
3 Press the SELECT button to enter the interface menu.
4 Press NEXT until the text "Network 1
Setup" is shown on the display.
5 Press SELECT.
6 Press NEXT until "DHCP" is shown on
the display.
7 Press SELECT.
8 Press the NEXT button until "Off " is
shown on the second line of the interface.
9 Press SELECT.
10 Press START/STOP button to finish.
Quick Start Guide
Menu
Interface Menu
Interface Menu
Network 1 Setup
Network 1 Setup
DHCP
DHCP
Off