TallyGenicom 9045N Guide De Démarrage Rapide page 12

Chapter 2 Setting Up Your Printer
Preparing a Location for the Printer
Dimensions
Installation
Precautions
STOP
8
All manuals and user guides at all-guides.com
Printer Height: 404 mm (15.9 in)
Printer Width (left to right): 422 mm (16.6 in)
Printer Depth (front to back): 465 mm (18.3 in)
Before unpacking your laser printer, it is recommended that you read the
following to assist locating a suitable spot for your new laser printer. To make
optimum use of the printer, observe the following precautions when locating the
printer.
The installation surface must be stable and very sturdy to support the considerable weight of the
printer. If the printer falls over, there is a severe risk of injuries.
Place the printer on a horizontal, sturdy and stable surface. The printer may
cause injury if it falls over.
Always place the printer under the following conditions:
Temperature: 5 to 35º C (41º to 95º F)
Humidity: 15 to 85% (non-condensation)
Be sure to keep the temperature to below 28º C (82º F) if the humidity is 85%.
If the temperature changes drastically from a cold environment to a warm
environment, condensation may develop inside the printer and cause print
problems. Therefore, be sure to let the printer rest for some time to adjust to
the new temperature.
Do not subject the printer to direct sunlight or a malfunction may result.
Do not place the printer in a location with poor ventilation, or high level of
dust, otherwise a fire hazard or electric shock may result.
Do not place the printer near heaters or similar objects, otherwise a fire hazard
may result.
Quick Start Guide