Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
page 6
LAMP AIMING
With unit open, loosen the nut
1
and screw and aim the lamp
head to the desired position.
Nut
Washer
LAMP AIMING and WIRE DIAGRAM
With lamp heads aimed, begin by
2
tightening the nut until the gasket is
fully compressed.
(Torque spec: 12 in-lbs)
Gasket
WIRING DIAGRAM
Battery
Remote
Connector
Connector
Heater
AC input
Connector
Connector
LIFE SAFETY SOLUTIONS
TEL: 800-705-SERV (7378)
techsupport-emergency@acuitybrands.com
With nut secure, tighten the screw to
3
finish aiming procedure.
(Torque spec: 10 in-lbs)
Screw
Lamphead
Connector
Status LED
Connector
Federal Communications Commission (FCC)
Requirements:
This device complies with FCC Title 47, Part 15, Subpart B.
This device does not cause harmful interference.
www.lithonia.com
Part # 912-00032-001
Rev. B, 5/2019
© Acuity Brands Lighting, Inc. 2018-2019
All Rights Reserved.
Publicité
Table des Matières
