Daewoo International DRP-120 Manuel D'instructions page 7

Mains Supply
Connect the mains lead to the wall socket. The mains Supply is switched on. To
disconnect the set from the mains completely, withdraw the mains plug from the
wall socket.
Setting the Clock
1. Check the radio is switched off .
2. Press TIME/PROG for 3 seconds on the front panel to start clock setting.
3. Press PRESET + button for 12-hours/24-hours selection.
4. Press TIME/PROG on the front panel to hour setting.
5. To set the hours, press PRESET + or PRESET - while the display is still fl ashing.
6. Press TIME/PROG on the front panel to minute setting and follow same method for
minute setting. Press TIME/PROG to confi rm.
Setting The Alarm
1. Check the radio is switched off .
2. Press AL/MODE for 3 seconds on the front panel to start alarm setting.
3. To set the hours, press PRESET + or PRESET - . Press AL/MODE to minute setting
and follow same method.
4. Press AL/MODE again and press PRESET + or PRESET - to select the alarm sound as
"bb" (Normal alarm), "USB" or Rad "Radio".
5. Press AL/MODE to set the Snooze time: 5,10,15,20 or 25. Press AL/MODE to
confi rm.
Remark: Press AL/MODE to enable / disable the alarm function. An alarm icon will
appear on the display when it is switch on.
Snooze function
1. When your alarm sounds, you can press the SNOOZE/SLEEP Button to turn off the
alarm temporary for the snooze time duration selected. The radio will then turn
on again.
2. Snooze can be repeated until the AL/MODE Button is pressed.
Sleep function
1. Turn on the radio, press the SLEEP Button to select a time, you can choose 15 / 30
/ 45 / 60 / 75 / 90 or OFF.
For example, when the LED display shows 15 minutes, the radio turns on and then
turns off automatically after 15 minutes.
2. To turn off the radio at any time, press the ON / STAND BY Button.
ENG
7