Maintenance And Cleaning; Service Information; Storage; Disposal And Recycling - GardenMeister GM-LS-360 Traduction Des Instructions D'origine

Adjusting the brush height (fig. 1)
The seamless height adjustment (8) can be used to
adapt the leaf and grass collector to the respective
ground.
The best result is achieved when the brushes rub light-
ly against the surface and the leaf and grass collector
is moved quickly over the lawn.
1. Loosen the height adjustment (8).
2. Adjust the sweeping brush to the desired position.
3. Then tighten the height adjustment (8) again.
Emptying the collection bag (fig. 7)
To remove the collection bag (5) to empty it, take it by
the cross member (11) and pull it up.
m Attention! If metal, glass or sharp objects have
been swept, it is necessary to wear sturdy work gloves
when emptying the collection bag.

9. Maintenance and cleaning

m DANGER! Bodily injury!
Risk of injury and risk of product damage.
- Do not clean the product with a high pressure wa-
ter jet.
- Do not use chemicals including gasoline or sol-
vents for cleaning. Some of them can destroy im-
portant plastic parts.
• Use a damp cloth to clean the plastic parts.
• Remove dust and dirt from the product after each
use.
• If the brushes are not rotating reliably, the bearing of
the brushes may be dirty. Clean and lubricate the
bearing of the brushes.

Service information

With this product, it is necessary to note that the follow-
ing parts are subject to natural or usage-related wear,
or that the following parts are required as consuma-
bles.
Wearing parts*: sweeping brushes, wheels
* may not be included in the scope of delivery!
16 | GB

10. Storage

For any longer storage the product must be thoroughly
cleaned and stored so that unauthorised persons can-
not access it.
• Empty the collection bag.
• Use the height adjustment (8) to relieve the brushes.
• Store the product where it is dry.
To save space, the push bar can be folded. To do this,
loosen the screws, pull the push bar upwards and fold
it forward.

11. Disposal and recycling

The product is supplied in packaging to
avoid transport damage. This packaging is
raw material and can thus be used again or
can be reintegrated into the raw material cy-
cle.
The product and its accessories are made of different
materials, such as metal and plastic. Take defective
components to special waste disposal sites. Check
with your specialist dealer or municipal administration!